[LAU] Re: Using Gigaport-ex with pipewire - only shows 2 channels
Bill Purvis <[email protected]>
| Newsgroups | gmane.linux.audio.users |
|---|---|
| Message-ID | <[email protected]> |
On 24/10/2025 17:52, Paul Davis wrote: > Try changing the device profile to "pro audio" on the configuration > page of pulseaudio volume control (yes, i know it says pulseaudio but > it controls pipewire now) > Thanks, That has done the trick. Will that apply after reboots, or do I need to set it every time I boot up? I'm just testing on my laptop - the intended use is on the church organ, which boots up headless most of the time. I've not located any pippewire or wireplumber config file yet. Bill -- +---------------------------------------------+ | Bill Purvis G8DIO | |[email protected] | +---------------------------------------------+ _______________________________________________ Linux-audio-user mailing list -- linux-audio-user-cunTk1MwBs/[email protected] To unsubscribe send an email to linux-audio-user-leave-cunTk1MwBs/[email protected]