Re: Aurora Linux success?

Walter:

I compiled snort 1.9.1 on Aurora 1.0 just fine. My system info is:

cpu             : TI UltraSparc IIi
fpu             : UltraSparc IIi integrated FPU
promlib         : Version 3 Revision 15
prom            : 3.15.2
type            : sun4u
ncpus probed    : 1
ncpus active    : 1
Cpu0Bogo        : 665.19
Cpu0ClkTck      : 0000000013d92d40
MMU Type        : Spitfire


Reading specs from /usr/lib/gcc-lib/sparc64-redhat-linux/2.96/specs
gcc version 2.96 20000731 (Red Hat Linux 7.3 2.96-113)




Hope it helps...

Naresh
On Wed, 5 Mar 2003, Walter B. Burke wrote:

> Has anyone had any success building/using Snort on Aurora Linux?  I'm no
> stranger to Snort, Linux, or the SPARC platform, but this specific combo is
> giving me a headache.
>
> When I run snort after compilation, it throws Warnings at me about any
> output plugin I attempt to define as being unknown.
>
> After that, it exits a few seconds later with a Bus Error.
>
> --snip--
>
> -*> Snort! <*-
> Version 1.9.1 (Build 231)
> By Martin Roesch ([email protected], www.snort.org)
>
> Program received signal SIGBUS, Bus error.
> DecodeTCP (pkt=0x14338a "À\223", len=40, p=0xeffff350) at decode.c:1861
> 1861            ph.sip = (u_int32_t)(p->iph->ip_src.s_addr);
> (gdb)
>
> --snip--
>
> I can say that after watching this several times, it always stops in the
> same place.  Any help?  Questions?  Beer?
>
> Aurora Linux 1.0
> Snort 1.9.1
> Ultra 10
>
> Thanks,
> Walter Burke
>
>
> _______________________________________________
> aurora-sparc-user mailing list
> [email protected]
> http://lists.linuxpower.org/mailman/listinfo/aurora-sparc-user
>