IRQ problems
"Kyle Gordon" <[email protected]>
| Newsgroups | gmane.linux.aurora.user |
|---|---|
| Message-ID | <[email protected]> |
Total newbie question, but I can't find the answer anywhere: I have two NICs installed trying to set up a firewall, but they are both trying to nab the same IRQ. I added this to my silo.conf: append="ide=nodma ether=5,0xe000,eth0 ether=7,0x10000,eth1 rhgb quiet" And both cards still try to grab the same IRQ of 6. One is the on-board ethernet slot from a Sun Blade 100 and the other is a Compaq 10/100 WOL. Neither as far as I can see have tabs to switch IRQs around. _______________________________________________ Aurora-sparc-user mailing list [email protected] http://lists.auroralinux.org/mailman/listinfo/aurora-sparc-user Aurora FAQ: http://www.ecs.soton.ac.uk/~mas01r/aurorafaq.html