RE: Aurora-sparc-user Digest, Vol 37, Issue 7
"Douglas Cox" <[email protected]>
| Newsgroups | gmane.linux.aurora.user |
|---|---|
| Message-ID | <[email protected]> |
Mr Gaskins --
Thanks for the quick reply. You are quite correct, I did know that the
sparc5/170 was not supported, although I had read a couple of recent posts
indicating that aurora was running pretty well on that architecture. I
really began to suspect a driver problem when I experienced the kernel panic
on the SS4 after loading the qlogic module with the drives installed on that
machine.
As I said, the raid array appears to be working fine in debian on the
SS5. Do you think there's any way to use the array with aurora2.0b2 on the
SS4?
Thanks again!
Doug Cox
>
>Message: 2
>Date: Tue, 8 Aug 2006 18:19:23 -0700
>From: "Barry Gaskins" <[email protected]>
>Subject: Re: [Aurora-sparc-user] qlogicpti module on aurora 2.0 beta2
> installation
>To: "Aurora user discussion" <[email protected]>
>Message-ID:
> <[email protected]>
>Content-Type: text/plain; charset="iso-8859-1"
>
> Did you mean that you have a Sparc 5 with the 170 MHz processor? I
>think
>that the problem is the processor is not supported. It is not the same any
>other sparc processor. I dont think it has anything to do with your raid
>array.
> Read this in the aurorafaq:
>http://www.ecs.soton.ac.uk/~mas01r/aurorafaq.html#ss5_170
> - Barry Gaskins
_______________________________________________
Aurora-sparc-user mailing list
[email protected]
http://lists.auroralinux.org/mailman/listinfo/aurora-sparc-user
Aurora FAQ: http://www.ecs.soton.ac.uk/~mas01r/aurorafaq.html