RE: Netra T1 200 install problems

>> Install goes well after disabling IPv6, then at the end when I reboot it
>> always hangs at:
>> 
>> INIT: Entering runlevel: 3
>> Entering non-interactive startup
>> Starting background readahead: [  OK  ]
>> Checking for hardware changes [  OK  ]
>> Starting cpuspeed: [  OK  ]
>> Applying ip6tables firewall rules:
>> 

> Boot the system to single user: (at the silo prompt, hit tab to see the
> options, then type the one you want and append a 1, like this:
>
> silo: linux 1
>
> That should boot it to single user, well before these items kick in. If
> ntsysv is installed, run it, and disable cpuspeed (this may be locking
> you up, not the firewall) and ip6tables/iptables. If ntsysv isn't there,
> use chkconfig to disable these services. Then reboot normally.
>
> ~spot

Tried the single user mode and it got to here:

INIT: Entering runlevel: 1
Entering non-interactive startup
Starting cpuspeed: [  OK  ]

INIT: Sending processes the TERM signal

At which point it hangs, I then tried the interactive mode and choose not to
start the cpuspeed service. Managed to get it running and used ntsysv to
stop the cpuspeed service from starting automatically. System boots ok now,
I did notice 2 [FAILED] messages during startup is that normal??

Loading additional iptables modules: ip_conntrack_netbios_ns
ip_conntrack_ftp [FAILED]

And

Starting HAL daemon: [FAILED]

Thanks for the help.

Kevin

_______________________________________________
Aurora-sparc-user mailing list
[email protected]
http://lists.auroralinux.org/mailman/listinfo/aurora-sparc-user
Aurora FAQ: http://www.ecs.soton.ac.uk/~mas01r/aurorafaq.html