2.98: SCSI esp errors prevent installation on U1
"Adam Kropelin" <[email protected]>
| Newsgroups | gmane.linux.aurora.user |
|---|---|
| Message-ID | <[email protected]> |
After a successful install on my U60, I decided to dust off my U1 and give that a go. I'm unable to get very far due to SCSI (esp) errors. The installer kernel probes the bus successfully and locates sda with proper identity strings. However, it immediately thereafter starts aborting commands, reports a DMA error, resets the SCSI bus, and offlines the device. I can write down the exact dmesg errors if that is useful. (Is there a way to switch ttys during install with a serial console? That would save some writing...) I've tried multiple disks in various positions in the chassis as well as add/removing a SCSI cdrom drive to permute the bus, but all configs behave essentially the same. --Adam _______________________________________________ Aurora-sparc-user mailing list [email protected] http://lists.auroralinux.org/mailman/listinfo/aurora-sparc-user Aurora FAQ: http://www.ecs.soton.ac.uk/~mas01r/aurorafaq.html