Can't control mode on Netra T1 embedded sungem ethernet (sungem)
Serg Kazakoff <[email protected]>
| Newsgroups | gmane.linux.aurora.user |
|---|---|
| Message-ID | <[email protected]> |
Hello, aurora-sparc-user.
I use Aurora 2.0 on Sun Netra T1.
It has two ethernet interfaces served by module sungem.
It runs fine, but I have one little trouble:
Ethernet interface eth1 (signed eth0 on case label) always sayas that
it runs in 100 Mbit half duplex mode.
When I try ot set mode I need (100MB Full-duplex) using ethtool or
mii-tool, the command execs normally (with no message) but the next
state reading says 100mb-HD again.
I have tried the next commands:
# ethtool -s eth1 autoneg off speed 100 duples full
# mii-tool -F 100baseTx-FD eth1
with the same result:
# mii-tool eth1
eth1: no autonegotiation, 100baseTx-HD, link ok
# ethtool eth1
Settings for eth1:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised auto-negotiation: No
Speed: 100Mb/s
Duplex: Half
Port: MII
PHYAD: 0
Transceiver: externel
Auto-negotiation: on
Supports Wake-on: d
Wake-on: d
Current message level: 0x00000007 (7)
Link detected: yes
What else I can use to control modes on this interface?
--
Hi,
Serg mailto:[email protected]
_______________________________________________
Aurora-sparc-user mailing list
[email protected]
http://lists.auroralinux.org/mailman/listinfo/aurora-sparc-user
Aurora FAQ: http://www.ecs.soton.ac.uk/~mas01r/aurorafaq.html