System hangs up on LNX-BBC 2.1 during boot

Hi 

I hope someone had experienced similar problem or otherwise can help me
here.

When I boot the PC system (Celeron 366MHz,196MB RAM, Trio3D/2x) with 
LNX-BBC 2.1 it get hangs up during the boot stage. There were reported
message just before this problem happened. However,this problem did not
occur for LNX-BBC 1.6 version on this system.

The following reported messages:

[sniped message]
Mount /proc
Trying to mount LNX media
Unpacking modules
Trying to mount /dev/cdroms/cdrom0
VFS: Can't find ext2 file system on dev ide1 (22,0)
hdc: timeout waiting for DMA
ide_dmaproc: chipset supported ide_dma_timeout func only: 14

The bring the system to normal state, it had to be restarted through
cold-boot way.

regards
SK Lim

PS. I had used the kernel parameter "gentoo dma=no" at boot prompt to
get Gentoo 1.4-rc4 working on the above PC system. 


Disclaimer:-
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
This e-mail transmission is intended only for the use 
of the individual or entity named above and may 
contain information that is confidential, privileged,
and exempt from disclosure under applicable law. 
If you are not the intended recipient, you are hereby 
notified that any disclosure, copying, distribution, or use 
of any of the information contained in this transmission is 
strictly PROHIBITED. If you have received this transmission 
in error, please immediately notify me by e-mail at the 
above address.Thank you.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>