Installed memory in DIMM B of both channels. SNB native raminit reports memory in DIMM A?
Keith Hui <[email protected]>
| Newsgroups | gmane.linux.bios |
|---|---|
| Message-ID | <CANTF=bRdXhKCXk5cn-Fzwm6GpMxWXMaSDAg37wbuNx+N8ZytzA@mail.gmail.com> |
I'm having more fun with my P8Z77-M. I put my two sticks of GSkill Ripjaws in slots A2 and B2 (aka C0S1, C1S1) following manual recommendations. Surprise 1: It actually worked at full speed now! It previously would totally croak, at least when I hook up serial to watch things go. Installing only one at C1S0 still didn't boot. And that's with me putting my max memory clock back to 800. Surprise 2: This is why I'm writing this email. I got this in the console: ... [DEBUG] memcfg DDR3 ref clock 133 MHz [DEBUG] memcfg DDR3 clock 1596 MHz [DEBUG] memcfg channel assignment: A: 0, B 1, C 2 [DEBUG] memcfg channel[0] config (00630020): [DEBUG] ECC inactive [DEBUG] enhanced interleave mode on [DEBUG] rank interleave on [DEBUG] DIMMA 8192 MB width x8 dual rank [DEBUG] DIMMB 0 MB width x8 single rank, selected [DEBUG] memcfg channel[1] config (00630020): [DEBUG] ECC inactive [DEBUG] enhanced interleave mode on [DEBUG] rank interleave on [DEBUG] DIMMA 8192 MB width x8 dual rank [DEBUG] DIMMB 0 MB width x8 single rank, selected ... Am I seeing things? Why did it report memory in DIMMA when I put my memory in slot 1 only? Regards Keith _______________________________________________ coreboot mailing list -- [email protected] To unsubscribe send an email to [email protected]