Re: HID certification using PTS

Hi Frederic,

> I am testing HID (BlueZ utils 3.22) using latest PTS (2.3.1) and I got
> some problems with it :
>
> - currently, when performing a CreateDevice, input service connects  
> then
> disconnects from remote device. This makes some tests failed.
> What do you think if this does not disconnect (and create classic  
> device
> connection) ?

does using CreateSecureDevice helps? Can you verify with bluez- 
utils-3.29 and see if it is still a problem?

> - when kernel (2.6.22) receives a VIRTUAL_CABLE_UNPLUG from PTS (tests
> TC_HOS_HCR_BV_02_I and TC_HOS_HCR_BV_04_I) it does not close the L2CAP
> channels as PTS waits for.
> I take a look in 2.6.22 sources, and it seems to me this disconnection
> should happen, am I right ?
> Is it fixed in later kernel ?

I recall that there was a fix for this.

Regards

Marcel


-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace