Re: immediate unsolicited disconnect after hcitool cc
"Yuchih Liu" <[email protected]>
| Newsgroups | gmane.linux.bluez.devel |
|---|---|
| Message-ID | <[email protected]> |
Hi Marcel, On 2/18/07, Marcel Holtmann <marcel@ho...> wrote: > Hi Choi, > > > after I do "hcitool cc xx:xx:xx:xx:xx:xx" I have a connection > > I can see with "hcitool con" but after one or two seconds I can > > see in hcidump that an HCI disconnect command is sent and > > the connection is disconnected. > > don't use this command for piconet creation. Use higher layer like L2CAP > and RFCOMM. The kernel will create the needed ACL link for you and take > fully care of it. I am doing some experience on the HCI level. Is there any HCI command i could use to maintain connection for a while? I have tried "Write Link Supervision Timeout Command", but not work. Shall i do something like unpark and then park the slavers? Thanks very much for your help, Yuchih ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Bluez-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/bluez-devel