Re: btusb+sco failing to play sound through Jabra BT500v headset (was: SCO flowcontrol patch v4.4 on 2.6.25/6 causes) hardlocks when connecting to BT device

Hi Martin,

>> what about not using that patch at all? I am using the new audio
>> interface without that patch. And you wanna use the btusb driver
>> and since 2.6.27-rc4 that one actually has SCO support.
>
> If I had known... :)
>
> Unfortunately, I have not yet succeeded. I modprobed 'sco' and then
> ran headsetd as before, but that just prints
>
>  headsetd[9417]: Bluetooth headset daemon version 0.5
>  headsetd[9417]: Configuration phase ended: target bdaddr is 00:1A: 
> 45:14:EE:D7, timeout is 90000 ms
>  headsetd[9417]: Changing state: Idle-->Paging
>  headsetd[9417]: Changing state: Paging-->Connecting
>  headsetd[9417]: Changing state: Connecting-->Ready
>  headsetd[9417]: Changing state: Ready-->Opening

don't use headsetd. Use the audio stuff that comes with bluez-utils.

Regards

Marcel


-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/