Bluetooth on SUSE 10.3

Hi,

I am trying to install a D-Link DBT-120 USB Bluetooth adapter on OpenSUSE 10.3.
When I connect the adapter the log shows:
kernel: usb 3-1: new full speed USB device using uhci_hcd and address 2
kernel: usb 3-1: new device found, idVendor=0a5c, idProduct=2033
kernel: usb 3-1: new device strings: Mfr=0, Product=0, SerialNumber=0
kernel: usb 3-1: configuration #1 chosen from 1 choice
kernel: Bluetooth: Core ver 2.11
kernel: NET: Registered protocol family 31
kernel: Bluetooth: HCI device and connection manager initialized
kernel: Bluetooth: HCI socket layer initialized
kernel: Bluetooth: HCI USB driver ver 2.9
kernel: usbcore: registered new interface driver hci_usb
kernel: Bluetooth: Broadcom Blutonium firmware driver ver 1.1
kernel: usbcore: registered new interface driver bcm203x

And lsusb shows:
Bus 003 Device 002: ID 0a5c:2033 Broadcom Corp. BCM2033 Bluetooth

When I try to run "hcitool dev" I cannot see the adapter.

>From some documentation I have read that the lsusb result should be:
Bus 001 Device 018: ID 0a5c:2001 Broadcom Corp.
I have installed every required packages for BlueZ, including the firmware for
the BCM2033 chip. In the past I even installed this BT adapter easily on an
older version of SUSE. I was using bluefw to manually load the firmware into
the card but today this tool doesn't seem to exist anymore. So how could I load
the firmware into the adapter? Or any other suggestions are welcome.

Thanks.

--
Jean-Michel


----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/