Re: How to change the Hci packet size?

Thanks.. but I remember something in the Bluetooth standard like 'continue' 
flag in each HCI packet.. Who is responsible to fill this?
Thanks again marcel..


--------------------------------------------------
From: "Marcel Holtmann" <[email protected]>
Sent: Thursday, March 06, 2008 5:53 PM
To: "BlueZ users" <[email protected]>
Subject: Re: [Bluez-users] How to change the Hci packet size?

> Hi,
>
>> Hi, what it the largest packet size for the Hci?
>> Is it a configuration in the BlueZ or is it a configuration in the
>> adapter?
>
> don't bother in trying. The firmware inside the Bluetooth chip is
> responsible for doing this job. It will pick the packet type that is
> best suitable.
>
> Regards
>
> Marcel
>
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2008.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> Bluez-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/bluez-users 


-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/