ACL connection handle
Paul <[email protected]>
| Newsgroups | gmane.linux.bluez.user |
|---|---|
| Message-ID | <[email protected]> |
Hi,
I have a bluetooth module in which there is an option to select the
interface (HCI or PCM) for the next SCO connection.This is done by sending
an HCI command .So I can use hcitool cmd option right? From the manual of
the BT module I figured out the OCF and OGF of the command, now on the
parameter part it requires the ACL connection handle.
How I can I find out the connection handle for a particular connection?
Usually when I do a file transfer or try to play through the HCI
interface,hcidump shows
< ACL data: handle 256 flags 0x02 dlen 8
So can I use 256 in place of the ACL connection handle in the HCI command?
Thank you for your time and consideration,
Regards,
Matt
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Bluez-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bluez-users