Re: ACL connection handle

     Brad,
   I am using the infineon.When I play through the uart, I will give -D
bluetooth option to aplay  and this  will create an acl as well as sco
connection and route audio through uart.But if I am  using the pcm interface
, I will  route  audio to the pcm interface  on the host connected to the bt
module and use aplay without the bluetooth option right?,So I have to
create  an acl connection and then use the hcitool cmd to  switch the SCO
interface before I do aplay .So is that necessary to give the command from
inside the audio service ?How would I establish the acl connection? Can I
use rfcomm connect ?

Thanks again for your time,
Regards,
Matt.

On Tue, Mar 25, 2008 at 5:46 PM, Brad Midgley <[email protected]> wrote:

> Paul/Matt
>
> >      I have a bluetooth module in which there is an option  to select
> the
> > interface (HCI or PCM) for the next SCO connection.This is done by
> sending
> > an HCI command .
>
> the infineon works this way. I believe the timing of this hci command
> (after establishing acl, before establishing sco) will require the
> code to be invoked from inside our audio service.
>
> --
> Brad
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2008.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> Bluez-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/bluez-users
>

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/

_______________________________________________
Bluez-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bluez-users