Re: hciconfig hci0 reset bug

Hi Peter,

>> So, if I'm reading this correctly, you should issue the reset for all
>> CSR-based dongles with build id > 118.
>>
>> Am I on the right track here? Does this information look accurate  
>> to you
>> guys?
>
> This is basically correct in that the fix appeared in firmware  
> around then
> (the internal log says 117, but possibly that was never released--- 
> I've
> confined my search to the development side).
>
> However, it's not that simple in that releases of earlier firmware  
> branches
> were still being made for some time.  Our ID numbers increase  
> monotonically
> so these would have later numbers.  I haven't done an exhaustive  
> search;
> mostly these releases had L2CAP + RFCOMM on chip for embedded  
> applications,
> so you wouldn't care about them.  I don't see any evidence of a  
> later HCI
> release based on the old code, offhand (but don't take this as  
> gospel).

this is what Steven told me. We don't have to worry about the RFCOMM  
builds since they don't include a HCI interface.

> If you want to be quite sure not to pick up a build which didn't  
> have the
> fix for reset, you could restrict the change to BlueCore 2 and later  
> chips
> using the "bcget chipver" call.  The early branches without the fix
> only ever ran on BlueCore 1: the fix was made in major release 12 and
> BlueCore 2 first ran on major release 14.

No vendor specific setup/init quirks that would have to call vendor  
commands :)

Regards

Marcel


-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace