Re: bluez-utils for embedded platform cross compilation

I'm running bluez utils/libs on an arm9 linux platform, so far it works
perfectly fine.
however I'm using Kernel 2.4.21, with 2.6er the support is even better.

--Fritz

On Thu, May 29, 2008 at 7:30 PM, Ram kumar <[email protected]>
wrote:

> hi,
>      We are planning to use a Bluetooth module in our embedded platform.I
> have running arm-linux kernel with a version 2.6.24.
>
> I have also enabled the bluetooth support in the
> menuconfig->networking->bluetooth support.Iam assuming this will enable the
> bluez stack.Please let me know if iam wrong!!!!!
>
> I know that bluez stack has been integrated in to the 2.6.24 kernel.I hope
> i can enable the BT stack with kernel menuconfig.Please correct me if iam
> wrong.
>
> But i would like to know whether bluez-utils will cross-compile to arm
> platform.?
>
> any suggestions to support bluetooth for my embedded platform will be
> helpful to me ?
>
> Note:Iam using wi2wi combo module,that has both bluetooth and wifi
> capability and the bluetooth is from CSR and model is BC04 with uart
> interface to host processor AT91SAM9260.
>
> Regards,
> Ram
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2008.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> Bluez-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/bluez-users
>
>


-- 
Regards,
--Codefritz

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/

_______________________________________________
Bluez-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bluez-users