Re: pairing problems

Right Im using hcidump. This tool prints all hci packets.
However, unfortunately no new for my problem....

On Wed, Jun 11, 2008 at 12:27 AM, Mumia W.. <
[email protected]<paduille.4061.mumia.w%[email protected]>>
wrote:

> On 06/10/2008 12:21 PM, hong zhang wrote:
> > --- Martin Kupf <[email protected]> wrote:
> >> [...]
> >> Hcidump says the following:
> >>
> >>  HCI Event: Connect Request (0x04) plen 10
> >>   45 61 00 00 18 00 40 25 00 01
> >> < HCI Command: Accept Connection Request
> >> (0x01|0x0009) plen 7
> >>   45 61 00 00 18 00 01
> >>> HCI Event: Command Status (0x0f) plen 4
> >>   00 01 09 04
>
> > Martin,
> >
> > What do you do to turn on these messages?
> >
> > ---henry
> >
>
> Although I'm not too familiar with the command, Martin mentioned
> "hcidump." Read "man hcidump"
>
>
>
> -------------------------------------------------------------------------
> Check out the new SourceForge.net Marketplace.
> It's the best place to buy or sell services for
> just about anything Open Source.
> http://sourceforge.net/services/buy/index.php
> _______________________________________________
> Bluez-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/bluez-users
>



-- 
Regards,
--Codefritz

-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php

_______________________________________________
Bluez-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bluez-users