Re: Starting with openMosix
Talimades <[email protected]>
| Newsgroups | gmane.linux.cluster.openmosix.general |
|---|---|
| Message-ID | <[email protected]> |
Moreno Baricevic wrote: >On Wed, 2005-11-23 at 14:01, Talimades wrote: > > >>So, now openmosix start without problems. >>But, something bad is happening. >>In the master node there is two card network, eth0 (192.168.1.250) and >>eth1 (62.xxx.xxx.211). >>My openmosix.map (done by hand) is: >>1 192.168.1.250 1 >>2 192.168.1.1 1 >> >>Here you can see what happen with setpe: >> >>master # setpe -w -f /etc/openmosix.map >>setpe: the supplied table is well-formatted, >>but my IP address (62.xxx.xxx.211) is not there! >>master # >> >>Here you can see what happen after run omdiscd: >> >>master # showmap >>My Node-Id: 0xc5d3 >> >>Base Node-Id Address Count >>------------ ---------------- ----- >>0xc5d3 62.xxx.xxx.211 1 >>master # >> >>How I have to configure the master openmosix.map?? >> >> > >Your map is ok. Setpe looks for the first IP resolved for the local >host. Invert the entries order on your /etc/hosts: > 192.168.1.250 ... > 62.xxx.xxx.211 ... >or use this version of setpe (whatever is the order): > http://www.democritos.it/~baro/sw/setpe/setpe_08-02-2005.tgz > >Moreno > > > > > Ok, thank you very much. I have a cluster with two nodes! Have a nice day ------------------------------------------------------- This SF.Net email is sponsored by the JBoss Inc. Get Certified Today Register for a JBoss Training Course. Free Certification Exam for All Training Attendees Through End of 2005. For more info visit: http://ads.osdn.com/?ad_id=7628&alloc_id=16845&op=click