Re: omdiscd doesn't work
Talimades <[email protected]>
| Newsgroups | gmane.linux.cluster.openmosix.general |
|---|---|
| Message-ID | <[email protected]> |
Peter Cordes wrote: >On Wed, Nov 23, 2005 at 05:59:03PM +0100, Talimades wrote: > > >>Hello, >>I want to use autodiscovery, but the comand omdiscd doesn't work. >>I have two network cards in the master node. >> >>My route is: >> >>master # route -n >>Kernel IP routing table >>Destination Gateway Genmask Flags Metric Ref Use >>Iface >>192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1 >>62.xxx.xxx.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 >>0.0.0.0 62.xxx.xxx.1 0.0.0.0 UG 0 0 0 >>eth0 >> >>And this is what happen with omdiscd: >> >>master # omdiscd -n >>CRITICAL: bind failed on interface 0: Address already in use >>CRITICAL: Unable to initialize network. Exiting. >> >> > > omdiscd is using eth0, as you can see from the setpe output with 62.xxx... >Edit /etc/openmosix/openmosix.config and set AUTODISCIF=eth1 >(If you're unlucky, you might need to look at /etc/init.d/openmosix and see >where it's looking for config files...) > > > ok, thank you have a nice day ------------------------------------------------------- This SF.net email is sponsored by: Splunk Inc. Do you grep through log files for problems? Stop! Download the new AJAX search engine that makes searching your log files as easy as surfing the web. DOWNLOAD SPLUNK! http://ads.osdn.com/?ad_id=7637&alloc_id=16865&op=click