Re: Xen Cluster & DRBD

Am Donnerstag, 27. April 2006 18:51 schrieb E. S. Venkatraman:
> >When the second node boots, it doesn't get a 'default' entry in the
> >routing table. If I restart /etc/init.d/networking manually, everything
> >is setup properly and the failover works ok.
> >
> >I'm guessing the initial network setup is controlled by the root node?
> >Can anybody shed any light on how I get the routing table set up
> >properly without the manual intervention?
>
> Could it be that the file "/cluster/node2/etc/network/interfaces" has only:
>
> auto lo
> iface lo inet loopback
>
> but no entry for eth0.  This was the case for my 1.9.1 cluster on Debian
> Sarge.

This was the first I tried. This is not solving the problem. I use openssi1.2.
Secondary node has no network. Only when starting networking manually.
Dont know what is going wrong!

tia
stefan

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.1 (GNU/Linux)

iD8DBQBEUibBZUUABjKKbXURAs24AJwOrU8aO6+EhLqgVsOqs20N0bmCiACg/aU8
Moy+pXttK9Bp8UNQIhpwJMU=
=Kq7y
-----END PGP SIGNATURE-----