(no subject)
"Clint Thomas" <[email protected]>
| Newsgroups | gmane.linux.cluster.ssic.user |
|---|---|
| Message-ID | <[email protected]> |
I'm looking for some help or assistance in setting up an OpenSSI cluster
here at work. We're looking at doing some HPC applications with some
servers we already have and OpenSSI seems like the direction to go for
this. I'm trying to get a feel for setting up the cluster on some dummy
machines before moving to our main servers, but I'm having a real issue
with getting it to run. After a successful install on either FC3 with
SSI 1.9.1 or FC2 with SSI 1.2.2, there is an error when I go to boot
into the kernel that says something to the extent of
kdb_cmd[0] : bpa panic_hook
Instruction(i) BP #0 at 0xC0128830 (panic_hook)
is enabled globally adjust 1
and it goes on like that with the FC3 install. I've gone back in and run
ssi-create to reinstall the config file, and mkinitrd --cfs, But it has
not changed anything. I tried to run ssi-ksync, but it will not let me
run since I am not booted into an SSI Kernel. The main machine is a Dell
Dimension 4100 w/ an 800MHz Pentium 3, 256mb of system ram, and a 60 gig
hard drive. The only post I have found in the mailing list that even
pertains to this is located here.
http://article.gmane.org/gmane.linux.cluster.ssic.devel/4718
Clinton Thomas
Soneticom Inc.
321-733-0400 ext. 424
[email protected]