Can not add second node in OPENSSI

Hello All,

I'm trying to run openssi on two identical node.

First node(init node) is working perfectly.

When I try to boot 2nd node, it gets the ip address, dhcp, it boots up with
kernel. But then it fails to find the NIC card.

It is using tg3. It's in the modprobe as expected. Since both pcs are
identical, I am assuming that I wouldn't need any further driver to install.

I've tried to add bnx2 instead of tg3. But I am not able to do so (not good
at linux)

Error message:

/lib/tg3.o : init_module: no such device
Unable to find NIC


Any help will be appreciated.

Thanks
-abu

------------------------------------------------------------------------------

_______________________________________________
Ssic-linux-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/ssic-linux-users