Re: loop-aes boot failure

Mike Mohr wrote:
> I'm having trouble getting loop-aes to boot an encrypted hard disk.  I
> do my testing using qemu, because I don't have to burn CDs over and
> over if things go wrong.  At boot time I get about 6-8 pf these errors
> repeated on the system console:
> 
> Command "/lib/losetup -e AES256 -I 0 -K /lib/rootkey.gpg -G /lib
> /dev/loop5 /dev/hda" returned error.

Your build-initrd.sh config says (USEMODULE=1 default) to load a loop.ko
module to kernel. But there is no module to load, and no error message
saying "/lib/insmod /lib/modules-...." returned error.

That means your build-initrd.sh config "build_in.con" is not the one you
used. Please provide the correct one. It is difficult to see what goes wrong
if I can't see the real config source.

-- 
Jari Ruusu  1024R/3A220F51 5B 4B F9 BB D3 3F 52 E9  DB 1D EB E3 24 0E A9 DD

-
Linux-crypto:  cryptography in and on the Linux system
Archive:       http://mail.nl.linux.org/linux-crypto/