Re: Emdebian and flash

Netgear Stora:

 ** MARVELL BOARD: RD-88F6281A LE

U-Boot 1.1.4 (Jul 31 2009 - 10:33:00) Marvell version: 3.4.14

U-Boot code: 00600000 -> 0067FFF0  BSS: -> 006CEE60

Soc: 88F6281 A0 (DDR2)
CPU running @ 1000Mhz L2 running @ 333Mhz
SysClock = 333Mhz , TClock = 200Mhz

DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000   size  64MB
DRAM CS[1] base 0x04000000   size  64MB
DRAM Total size 128MB  16bit width
Flash:  0 kB
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:256 MB

CPU : Marvell Feroceon (Rev 1)

Streaming disabled
Write allocate disabled

Module 0 is RGMII
Module 1 is TDM

USB 0: host mode
PEX 0: interface detected no Link.
Net:   egiga0, egiga1 [PRIME]
Hit any key to stop autoboot:  0
Marvell>>




On Tue, Nov 8, 2011 at 20:22, Neil Williams <[email protected]> wrote:

> On Tue, 8 Nov 2011 20:06:44 +0100
> Vítor Dias <[email protected]> wrote:
>
> > Need help to install emdebian in my netgear stora nand flash...
>
> How much storage is available? Emdebian Grip needs 75Mb or so for a
> base system. Emdebian does not provide kernels typically, so you will
> need to sort that yourself.
>
> PS If you're asking a new question, please start a new thread, instead
> of replying to someone else's message with a different question.
>
> --
>
>
> Neil Williams
> =============
> http://www.linux.codehelp.co.uk/
>
>