Re: unstable/sid: libgtk-3-0 and libgtk-3-0-dbg

Double facepalm!  I missed this sentence on the wiki: :"If an
appropriate package was found you should just be able to install the
appropriate debug package... and skip the rebuilding process in the
following instructions and go straight to running gdb."

Thanks,
Arpe

On Thu, Feb 2, 2017 at 7:11 PM, Jordi Mallach <[email protected]> wrote:
> El dj 02 de 02 de 2017 a les 00:02 +0800, en/na Kevin Connor Arpe va
> escriure:
>> You are right.  That is my mistake.  (When I get a wiki account
>> setup,
>> I'll make a note for futures readers... *not* root!)
>>
>> I decided to backup one step and try to build a debug version of
>> libglib2.0-0.  Following the same steps from that page... but it
>> fails
>> during the test phase:
>> (You can spot the "^C" below.  The build just hung at this point.  I
>> tried twice.  Let it hang for 10+mins, then Ctrl+C to give up.)
>>
>> Any ideas?
>
> You were already pointed to the debug archive, so you can use the
> -dbgsym packages. Is there a problem with that?
>
> --
> Jordi Mallach Pérez  --  Debian developer     http://www.debian.org/
> [email protected]     [email protected]     http://www.sindominio.net/
> GnuPG public key information available at http://oskuro.net/