Re: Translation status robot (again?)

El 2024-07-27 a las 11:51 +0200, Holger Wansing escribió:

> Hi again,
> 
> Am 27. Juli 2024 09:43:07 MESZ schrieb "Camaleón" <[email protected]>:
> >El 2024-07-26 a las 23:51 +0200, Holger Wansing escribió:
> >> Long story short:
> >> the repeating complaining about "Translation status page not updated (again)" 
> >> and similar may look as an issue at the first glance, but as far as I can see, 
> >> there is no problem currently.
> >> It's just that the system is working diffently compared to how people think
> >> it does.
> >> 
> >> There is room for optimization probably, but the status quo is working as
> >> intended.
> >
> >I beg to differ.
> >
> >These pages (not just for «es» but other languages)
> >
> >https://www.debian.org/international/l10n/po-debconf/es
> >
> >Need to reflect the CURRENT and REAL status of PO files when a translator
> >interacts with the robot.
> 
> Is it really necessary, that this is *all* visible on *one* page? I guess no.
> It would be fine, but not strictly needed.
> 
> >So, for multispeech file, the one I'm complaining about, this must 
> >reflect a grey table row color and:
> >
> >-------------------------------------------------------------------------------------------------------
> >multispeech 0% (0t;0f;16u)			bts	Camaleón	2024-07-21 06:36:01	1076657
> >-------------------------------------------------------------------------------------------------------
> >
> >But currently it is displayed as «Hey, no one is in care  of this file, 
> >is not translated... you can go ahead and translate it into Spansish» 
> >which, being this page the main source for translator's coordination, 
> >I guess is not the desired/expected message :-/
> 
> All the information is there, but divided on two pages.

(...)

So, finally... what do I have to do (should I can do anything on my 
side) for «multispeech» po-debconf file (Spanish ES) shows its current 
translation status (fully translated and sent to BTS) at the stats 
page?:

https://www.debian.org/international/l10n/po-debconf/es

O:-)

Thanks!