Re: RAID Detection using intel VROC (VMD)
Sven Schumacher <[email protected]>
| Newsgroups | gmane.linux.debian.fai |
|---|---|
| Message-ID | <[email protected]> |
Hi Thomas, > Am 16.09.2021 um 09:58 schrieb Thomas Lange <[email protected]>: > > >> >>>>>> On Thu, 16 Sep 2021 08:44:05 +0200, Sven Schumacher <[email protected]> said: > >> Booting fai detects only the ssd and hdd, but not the raid-volumes. At that stage setup-storage fails, because I specified md124 for disk_config-file. > >> So two problems: >> - how can I get fai to automatically detect the existing raid? >> - how can I get grub-efi to find the grub.cfg after running update-grub later > > Did you check if FAI is loading the vroc driver? What is the device > name of this Intel soft raid? I just used mdadm without doing any modprobe or insmod, to get it recognize the raid. So I assume the kernel 5.10.0-8 includes the driver (kernel 5.10.0-4 wasn’t working). When I tried “mdadm --detail-platform” with 5.10.0-4 there was no raid controller detected, using 5.10.0-8 there is some output telling me on which Ports the hdd and ssd are attached. Sincerely Sven Schumacher > > -- > viele Grüße Thomas