Identify disks for setup-storage

Hi all,

a rather old issue, one that I always only did crappy workarounds for:

How to tell FAI which disks to use for installation?

Currently I have a server with just 4 devices, two of which are supposed to become the target for FAI as a software-raid-1. (At other times I had 
boxes with a mere 72 devices...)

In a stopped FAI attempt, the "disk_list" variable is just 'sda sdb sdc sdd'. I can check and tell that it should have been sdb and sdd - so I write 
"disk2" and "disk4" into my setup-storage config.
And of course the next time, the order of disks will be different, and it should be disk2 and disk3, or whatever.


In the past, I created a hook, skipping the entire setup-storage business, extracted some identifier, e.g. the Vendor string, using hwinfo or a 
similar tool, and fed that into a script running parted, mkfs etc.

All very easy to read, very server-specific and non-automatic.


But I wonder if there is'nt a more elegant way that actually uses setup-storage?


Cheers
Thomas

-- 
--------------------------------------------------------------------
Thomas Roth
Department: IT


GSI Helmholtzzentrum für Schwerionenforschung GmbH
Planckstraße 1, 64291 Darmstadt, Germany, www.gsi.de

Commercial Register / Handelsregister: Amtsgericht Darmstadt, HRB 1528
Managing Directors / Geschäftsführung:
Professor Dr. Paolo Giubellino, Dr. Ulrich Breuer, Jörg Blaurock
Chairman of the Supervisory Board / Vorsitzender des GSI-Aufsichtsrats:
State Secretary / Staatssekretär Dr. Volkmar Dietz