Re: [RFR] po-debconf://bitcoin-knots/de.po

hjb-news <[email protected]>
Newsgroups gmane.linux.debian.internationalization.german
Message-ID <[email protected]>
Am Freitag, dem 08.05.2026 um 17:57 +0000 schrieb Helge Kreutzmann:
> Moin Mitübersetzer,
> da es auch wieder Bitcoin war und die letzten Male sich keiner
> meldete, habe ich die Übersetzung aktualisiert; von Bitcoin und den
> Konzepten habe ich leider keine große Ahnung.
> 

Hallo Helge,

#. Type: error
#. Description
#: ../bitcoin-knots.templates:6001
msgid "Couldn't configure txindex"	
msgstr "Txindex konnte nicht konfiguriert werden."

Die Verwendung von Satzendezeichen zwischen Original und Übersetzung
ist nicht konsistent.

#. Type: string
#. Description
#: ../bitcoin-knots.templates:7001
msgid ""
"A larger cache can speed up the initial synchronization of your
Bitcoin "
"node,   but after the initial sync is complete, a larger cache value
does "
"not  significantly improve performance and may use more RAM than
needed."
msgstr ""
"Ein größerer Zwischenspeicher beschleunigt die anfängliche
Synchronisation "
"Ihres Bitcoin-Knotens, nach Abschluss der anfänglichen Synchronisation
"
"verbessert ein größerer Zwischenspeicher allerdings nicht wesentlich
die "
"Leistung und könnte mehr Arbeitsspeicher als notwendig verwenden."

s/beschleunigt/kann ... Bitcoin-Knotens beschleunigen/ (?)

#. Type: string
#. Description
#: ../bitcoin-knots.templates:29001
msgid "Keep the transaction memory pool below <n> megabytes"
msgstr "Hält den Transaktions-Speicher-Fundus unter <n> megabyte"

"Fundus" ?; ich würde es bei "Pool" belassen.


#. Type: string
#. Description
#: ../bitcoin-knots.templates:41001
msgid ""
"Maximum size of data in data carrier transactions to relay and mine,
in bytes"
msgstr ""
"Maximale Größe von Daten im Daten-Übertragungstransaktionen zum
Weiterleiten "	
"und Minen, in Byte"

s/im/in/

Freundliche Grüße
Hermann-Josef
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.