serial console and linuxrc script
Marc Haber <[email protected]>
| Newsgroups | gmane.linux.debian.knoppix |
|---|---|
| Message-ID | <[email protected]> |
Hi, I am using a modified 3.3 CD. The kernel has been changed to 2.4.26 with support for serial console enabled. When I start with knoppix console=ttyS0, this works for the boot messages output by the kernel itself, but once the linuxrc script starts running, output is again on the monitor. When starting a real Debian GNU/Linux with console=ttyS0, output stays serial until the getty is started, with no output on the system's monitor at all. So there must something go different between knoppix and Debian. I wasn't able to figure it out. Can anybody help? Greetings Marc -- ----------------------------------------------------------------------------- Marc Haber | "I don't trust Computers. They | Mailadresse im Header Karlsruhe, Germany | lose things." Winona Ryder | Fon: *49 721 966 32 15 Nordisch by Nature | How to make an American Quilt | Fax: *49 721 966 31 29