Re: RAID1 all bootable

Francesco Pietra <[email protected]>
Newsgroups gmane.linux.debian.ports.amd64,gmane.linux.debian.user
Message-ID <CAEv0nmtUsckE5fYJpTY-fnkYhZZCH44h4w9J_G=2eqe=0DnPqQ@mail.gmail.com>
On Tue, Mar 5, 2013 at 7:30 PM, Bob Proulx <[email protected]> wrote:
> Francesco Pietra wrote:
>> Thanks so much for this manual. Unfortunately, I have no more the
>> initial situation (one HD replaced) because I was hurried by an editor
>> to provide computational data from my CUDA server. I did not want to
>> run the server before all my data were backed up. Therefore I did a
>> fresh amd64 wheezy install on both disks, the old one and the newly
>> replaced. The installation ended with:
>
> Sad to see that you have given up already and destroyed your data.

I had all my data on another raid1 machine. Following the new install,
all data were scp transferred. All my machine are on a router, with
passwordless scp. Which is also used to contact external server for
computational work.

>  Oh
> well.
>
>> Nonetheless, I'll try to digest your "manual". At this point, could
>> you also describe how to safely proceed, on this situation, to have
>> grub on both disks? It would be useful community wide, to complete the
>> raid1 installation from the Debian installer.
>
> As was already mentioned:
>
>   # grub-install /dev/sda
>   # grub-install /dev/sdb
>
> Newer Debian installers will give the option to install to both disks
> but older ones do not.
>
>> (on the above situation I commanded "grub-install /dev/sdb",
>> whereby, at next boot, grub was no more found, and the system
>> entered "grub rescue", from where I restored the situation of grub
>> on sda only.
>
> Running 'grub-install /dev/sdb' should work.  If it does not then
> something is wrong.  Unfortunately you will need to debug it.

Following a seemingly correct installation, with grub installed
'grub-install /dev/sda' and 'update grub'

command

 grub-install /dev/sdb


led to a system that did no more boot. I can't see what was wrong with
the installation. I have now the same situation (install from the
wheezy installer). If you suggest what to check, I'll do that.

Thanks a lot for your generous help. I (we) learned a lot from you.

francesco pietra
>
> Bob
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.