Installing on RP3410

Hello,

I=E2=80=99m having issues when trying to install a new rp3410. On the new cd=
 images I get=20

Branching to kernel entry point 0x000e0000. If this is the last message you s=
ee you may need to switch your console.=20

I=E2=80=99m using the management console via serial.  I=E2=80=99m not sure w=
hat other options there are to switch to.=20

Using a very old image I can get it to boot into the installer but it doesn=E2=
=80=99t detect the cd rom. The difference in early boot is that it detects t=
he machine as a rp3410 then boots as it should.=20

The ipl settings are the same with all the images I=E2=80=99ve used.=20

Are there any kernel parameters I should try in ipl?

When I get the console redirect message I get a red flashing light on the fr=
ont panel and the machine is unresponsive and even the management console st=
ops functioning. Given that it boots an older image I doubt it is hardware r=
elated. The only thing I can think of is it trying to redirect to the vga ha=
rdware that isn=E2=80=99t functional on these machines.=20

Any help would be greatly appreciated.=20

Mike Hosken=20
Sent via my iPhone=20=