Re: [PATCH 0/1] sched/topology: NUMA distance deduplication

Valentin Schneider <[email protected]>
Newsgroups gmane.linux.ports.ia64,gmane.linux.kernel,gmane.linux.debian.ports.ia64
Message-ID <[email protected]>
Hi,

On 17/03/21 20:04, John Paul Adrian Glaubitz wrote:
> Hi Valentin!
>
>> As pointed out by Barry in [1], there are topologies out there that struggle to
>> go through the NUMA distance deduplicating sort. Included patch is something
>> I wrote back when I started untangling this distance > 2 mess.
>>
>> It's only been lightly tested on some array of QEMU-powered topologies I keep
>> around for this sort of things. I *think* this works out fine with the NODE
>> topology level, but I wouldn't be surprised if I (re)introduced an off-by-one
>> error in there.
>
> This patch causes a regression on my ia64 RX2660 server:
>
> [    0.040000] smp: Brought up 1 node, 4 CPUs
> [    0.040000] Total of 4 processors activated (12713.98 BogoMIPS).
> [    0.044000] ERROR: Invalid distance value range
> [    0.044000]
>
> The machine still seems to boot normally besides the huge amount of spam. Full message
> log below.
>
> Any idea?
>

Harumph!

The expected / valid distance value range (as per ACPI spec) is
[10, 255] (actually double-checking the spec, 255 is supposed to mean
"unreachable", but whatever)

Now, something in your system is exposing 256 nodes, all of them distance 0
from one another - the spam you're seeing is a printout of

  node_distance(i,j) for all nodes i, j

I see ACPI in your boot logs, so I'm guessing you have a bogus SLIT table
(the ACPI table with node distances). You should be able to double check
this with something like:

$ acpidump > acpi.dump
$ acpixtract -a acpi.dump
$ iasl -d *.dat
$ cat slit.dsl

As for fixing it, I think you have the following options:

a) Complain to your hardware vendor to have them fix the table and ship a
   firmware fix
b) Fix the ACPI table yourself - I've been told it's doable for *some* of
   them, but I've never done that myself
c) Compile your kernel with CONFIG_NUMA=n, as AFAICT you only actually have
   a single node
d) Ignore the warning


c) is clearly not ideal if you want to use a somewhat generic kernel image
on a wide host of machines; d) is also a bit yucky...
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.