RE: please give-back psi4 on mips

Hello,

it failed, but with different error, this time.

Since it  failed on lucatelli,
I tried to build it again, but this time on Cavium boards.

It failed for both,
mips and mipsel build,
with the same error as last try one lucatelli:

> echo "Testing tu5-sapt..."
> Testing tu5-sapt...
> /usr/bin/make -C tu5-sapt; true
> .........
> Build killed with signal TERM after 300 minutes of inactivity


As I see from debian build logs for psi4,
it was successfully built only ones on eberlin,
which is a Loongsoon 3A.
Beside of that, Anibal and I
built it successfully on non-Cavium boards.
It seems to me that this error could be
Cavium specific issue.


I will try to further investigate this behavior.



________________________________________
From: Anibal Monsalve Salazar [[email protected]] on behalf of Aníbal Monsalve Salazar [[email protected]]
Sent: Saturday, April 05, 2014 7:20 PM
To: Aurelien Jarno
Cc: [email protected]; [email protected]; Dejan Latinovic
Subject: Re: please give-back psi4 on mips

On Fri, 2014-04-04 19:35:41 +0200, Aurelien Jarno wrote:
> On Fri, Apr 04, 2014 at 10:43:11AM +0000, Aníbal Monsalve Salazar wrote:
>>
>> Please give-back psi4 on mips.
>>
>> It builds fine for Dejan and myself on two different machines.
>>
>> gb psi4 . mips
>
> Done.

Failed.

Dejan thinks it fails possibly because of not enough RAM.

According to https://db.debian.org/machines.cgi?host=lucatelli lucatelli
is a 16 x Cavium Octeon V0.3 with 1.8G. Its RAM is about the same I'm
using to build psi4 with pbuilder.

I could upload my binary package and my pbuilder log file if required.