Re: M4000 failing to boot Debian Sparc64

Dennis Clarke <[email protected]>
Newsgroups gmane.linux.debian.ports.sparc
Organization GENUNIX
Message-ID <[email protected]>
On 7/2/23 17:19, John Paul Adrian Glaubitz wrote:
> Hi Dennis!

Good day to you Sir!

> 
> On Sun, 2023-07-02 at 14:34 -0400, Dennis Clarke wrote:
>> You are likely kicking a dead horse. That M4000 is similar to my M3000
>> and you will never ever get Linux to run there. Ever. Unless you have a
>> few million dollars for research and development and then be able to
>> push all the good research upstream into the Linux kernel.
> 
> I don't think that's true. Since it has been reported that these machines
> run OpenBSD, it should be a matter of reading the OpenBSD kernel sources
> and add the missing bits and pieces for the SPARC64 VII(+) machines to the
> Linux kernel.

Are we certain about NetBSD or OpenBSD? I did try to install NetBSD and
that failed also. I think I have my notes on that somewhere but it would
be easy enough for me to try again.

> 
> I don't think that would be much as this it just some board-specific code
> and it wouldn't probably take an experienced kernel developer longer than
> a month if at all.

That brings the costs down to the level of reasonable. Let me ponder
that a while.
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.