Begin: Mounting root file system ... /init: line 221: arithmetic syntax error

Well, this is interesting :


[   23.462584] This architecture does not have kernel memory protection.
[   23.636642] Run /init as init process
Loading, please wait...
/scripts/init-top/udev: line 14: can't create /sys/kernel/uevent_helper: 
Permission denied
Begin: Loading essential drivers ... [   24.311877] SCSI subsystem 
initialized
[   24.842426] pata_ali 0000:00:0d.0: enabling device (0004 -> 0005)
[   25.012970] scsi host0: pata_ali
[   25.105325] scsi host1: pata_ali
[   25.193444] ata1: PATA max UDMA/66 cmd 0x1fe02010200 ctl 
0x1fe02010218 bmdma 0x1fe02010220 irq 12 lpm-pol 0
[   25.321678] ata2: PATA max UDMA/66 cmd 0x1fe02010210 ctl 
0x1fe02010208 bmdma 0x1fe02010228 irq 12 lpm-pol 0
[   25.759898] ata1.00: ATA-5: ST340016A, 3.10, max UDMA/100
[   25.830961] ata1.00: 78165360 sectors, multi 0: LBA
[   26.050457] scsi 0:0:0:0: Direct-Access     ATA      ST340016A 
3.10 PQ: 0 ANSI: 5
[   26.935164] ata2.00: ATA-6: ST340014A, 8.01, max UDMA/100
[   27.006267] ata2.00: 78165360 sectors, multi 0: LBA48
[   27.607854] scsi 1:0:0:0: Direct-Access     ATA      ST340014A 
8.01 PQ: 0 ANSI: 5
modprobe: module tulip.ko not found in modules.dep
modprobe: module auth_rpcgss.ko not found in modules.dep
modprobe: module dmfe.ko not found in modules.dep
modprobe: module flash.ko not found in modules.dep
modprobe: module lockd.ko not found in modules.dep
modprobe: module loop.ko not found in modules.dep
modprobe: module nfs.ko not found in modules.dep
modprobe: module nfs_acl.ko not found in modules.dep
modprobe: module nfsd.ko not found in modules.dep
[   29.496486] sd 0:0:0:0: [sda] 78165360 512-byte logical blocks: (40.0 
GB/37.3 GiB)
[   29.597089] sd 1:0:0:0: [sdb] 78165360 512-byte logical blocks: (40.0 
GB/37.3 GiB)
[   29.771089] sd 1:0:0:0: [sdb] Write Protect is off
[   29.834362] sd 0:0:0:0: [sda] Write Protect is off
[   29.897614] sd 1:0:0:0: [sdb] Write cache: enabled, read cache: 
enabled, doesn't support DPO or FUA
[   30.016830] sd 0:0:0:0: [sda] Write cache: enabled, read cache: 
enabled, doesn't support DPO or FUA
[   30.136138] sd 1:0:0:0: [sdb] Preferred minimum I/O size 512 bytes
[   30.217751] sd 0:0:0:0: [sda] Preferred minimum I/O size 512 bytes
[   30.340686]  sda: sda1 sda2 sda3 sda4
[   30.391482] sd 0:0:0:0: [sda] Attached SCSI disk
[   33.940513]  sdb: sdb1 sdb2 sdb3 sdb4
[   33.991486] sd 1:0:0:0: [sdb] Attached SCSI disk
modprobe: module sg.ko not found in modules.dep
modprobe: module sunrpc.ko not found in modules.dep
modprobe: [   34.183107] Kernel panic - not syncing: Attempted to kill 
init! exitcode=0x00000200
[   34.288481] CPU: 0 UID: 0 PID: 1 Comm: init Not tainted 
6.12.3-sparc64-smp #1  Debian 6.12.3-1+sparc64
[   34.410847] Call Trace:
[   34.442944] [<0000000000ef8e70>] dump_stack+0x8/0x18
[   34.508199] [<0000000000eeb430>] panic+0xf4/0x398
[   34.570023] [<0000000000474574>] do_exit+0xab4/0xac0
[   34.635274] [<0000000000474744>] do_group_exit+0x24/0xa0
[   34.705101] [<00000000004747dc>] sys_exit_group+0x1c/0x40
[   34.776069] [<0000000000406214>] linux_sparc_syscall32+0x34/0x60
[   34.855064] Press Stop-A (L1-A) from sun keyboard or send break
[   34.855064] twice on console to return to the boot prom
[   35.001455] ---[ end Kernel panic - not syncing: Attempted to kill 
init! exitcode=0x00000200 ]---
module usbcore.ko not found in modules.dep
modprobe: module platform:f0069d48 not found in modules.dep
modprobe: module platform:root not found in modules.dep
done.
Begin: Running /scripts/init-premount ... done.
Begin: Mounting root file system ... /init: line 221: arithmetic syntax 
error
~
Type  'go' to resume
ok power-off

lom>
LOM event: +0h32m20s host power off
lom>