Re: PPPoE access server

Yeah, is a good solution.

We have a dell r410, nic intel and broadcom,

around 4K customers, with bandwith control running verry well.

bsd 7.1, mpd5, radius authentication.

Good setup. It's works.

--
*Alex Montoanelli*
 » Unetvale <http://www.unetvale.com.br>
 » +55 48 3263 8789
 » INOC 53175*100*
*


On Tue, Mar 5, 2013 at 4:16 AM, Adrian Minta; <[email protected]> wrote:

> Is not a debian solution, but some providers in my country have
> successfully use the following combination: FreeBSD+MPD5+Intel NIC.
>
>
>
> On 03/04/2013 10:06 PM, C.J. Adams-Collier KF7BMP wrote:
>
>> Hello folks,
>>
>> I'm thinking about changing my current subscriber setup from extending a
>> single L2 bridge to all customers over to PPPoE.  I expect that I can
>> then perform rate limiting with pppd, get a better sense of usage by way
>> of RADIUS as well as allowing customer devices to authenticate
>> themselves when they establish their ppp session.
>>
>> Is there any documentation on setting up such an access server?  The
>> only ppp docs I found with a basic search of the terms were from the
>> good olde modem days.  I was hoping I was missing something pretty
>> drastic.  Perhaps folks have switched to 802.1x?  Perhaps nobody uses
>> linux as an access server?
>>
>> Thanks in advance,
>>
>> C.J.
>>
>>
>
> --
> To UNSUBSCRIBE, email to debian-isp-REQUEST@lists.**debian.org<[email protected]>
> with a subject of "unsubscribe". Trouble? Contact
> [email protected]
> Archive: http://lists.debian.org/**[email protected]<http://lists.debian.org/[email protected]>
>
>