Re: No postings

Hi Per,

I forget where this came from, but here's the top of my authsimple file:

# Simple authorization for diald control via TCP connection
# (normally for dctrl running on a workstation)

# format is:  name  allow,allow,allow..
#        or:  name  0x<hex allow bits>
#   where allow is one or more of: none, control, config, block, unblock,
#                                  force, unforce, down, up, delquit, quit,
#                                  reset, queue, debug, dynamic, monitor,
#                                  message, connect, demand, nodemand, auth.

# eg:
# thisuser up,down,message,connect
# totalaccess 0xFFFFFFFF


Sorry, I don't know offhand which allows correspond with which bits for 
the hex format.

In diald.conf:
authsimple /path/to/auth/file

Mark.


Per Jessen wrote:

> All,
>
> I've just rejoined this list after a break - it's pretty quiet
> around here ? I guess diald is working pretty well ... :-)
>
> I was mainly looking for some info on the authsimple file -
> found it in a list archive, but shouldn't it be part of the
> doc too ? (diald-1.0)
>
>
>
>
>
> regards,
> Per Jessen, Zurich
> http://www.enidan.com - home of the J1 serial console.
>
> Genius may have its limitations, but stupidity is not thus handicapped.
>
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-diald" in
> the body of a message to [email protected]
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
>


-
To unsubscribe from this list: send the line "unsubscribe linux-diald" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html