Re: Stop in stage 2

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Terry Mackintosh wrote:
> Hi all
> 
> 
> Benjamin Schieder wrote:
> 
>> -----BEGIN PGP SIGNED MESSAGE-----
>> Hash: SHA1
> 
> <snip>
> 
>> That is indeed strange. Can you put the build_log
>> (build/foo/ROCK/logs/) up
>> somewhere together with your config/foo/config file?
> 
> 
> OK, in build/*/ROCK/logs the build_target logs had nothing of interest,
> but the build_job logs all have:
> 
> cannot set up thread-local storage: set_thread_area failed when setting
> up thread-local storage
> 
> Then a message follows that says as there is no .log file or .err file,
> it is creating an .err file. So that is were the empty .err file comes
> from.
> 
> As a reminder, this is a cluster build on a PIII. For the moment it is
> only the one box, so Build-Target and Build-Job are on the same box.
> However this problem was first found when also using the remote build
> nodes (also PIII's).
> 
> Attached is the config for the install target, and one build_job log.

This seems to be connected to NPTL.
https://listman.redhat.com/archives/phil-list/2003-August/msg00017.html

I'll try building here with your config and see what happens.

I'll keep you posted,
	Benjamin

- --
Go away, or I will replace you with a very small shellscript!
	http://shellscripts.org/
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.0 (GNU/Linux)

iD8DBQFD8NiQr0OTeImXvg8RAr+MAKC7ZFPB/3JDU747ImCunOkpqzLLSQCfR3Dl
6BsP4sOB6f8X7k9cgdLEZbA=
=e0xy
-----END PGP SIGNATURE-----