Re: [rock-user] SCSI

Hi

Most distributions of Linux, including general use ones based on Rock 
AFAIK, have all or most all possible SCSI support already built as 
modules.  Therefore an entry in the /etc/modules.conf file is all that 
is usually needed.  It has been a wail sense I've setup a SCSI based 
machine, so I don't remember the details but don't recall it being too hard.

Hope that helps

Terry

[email protected] wrote:
> You will need to know the type of SCSI controller card and compile
> the driver into the kernel or as a module. If you decide to compile
> the? driver as a module and are using the SCSI disk as the device
> with your operating system, then you will need to build a ramdisk
> (initrd). Hope this helps.
> 
> Donald Froien.
> 
> -----Original Message----- From: philippe florent
> <[email protected]> To: [email protected] Sent: Sun,
> 24 Jun 2007 7:21 pm Subject: [rock-user] SCSI
> 
> 
> hello,
> 
> is it possible to have ROCK linux recognize my scsi drives ?
> 
> 
> should I path anything or add a driver ?
> 
> 
> thx

-- 
Terry Mackintosh <terry-Iwt3gjr5Qw3AwKckeXIILgC/[email protected]>
http://www.mackintoshweb.com/mars/ Mars Society, FL chapter.
Proudly powered by ROCKLinux, Apache, PHP, PostgreSQL, etc.
"If you don't know where you are going, how can you get there?"