need some help with a container

Hi,

do I have any chance to reconfigure an volume set of 2 Partition to a mirror set ?..
I need a new mirror set with 16.9 GB. Is there any chance to change that on a running system via afacli ?
sorry for using this list. I\'m not sure if my question is right here. But I found nothing else ;)
thnx for any help

Kai


actual configuration:

Executing: container list
Num          Total  Oth Chunk          Scsi   Partition
Label Type   Size   Ctr Size   Usage   B:ID:L Offset:Size
----- ------ ------ --- ------ ------- ------ -------------
 0    Volume 16.9GB            Open    0:00:0 64.0KB:8.47GB
 /dev/sda             terence          0:01:0 64.0KB:8.47GB

Executing: disk list

B:ID:L  Device Type     Blocks    Bytes/Block Usage            Shared Rate
------  --------------  --------- ----------- ---------------- ------ ----
0:00:0   Disk            35566478  512         Initialized      NO     160
0:01:0   Disk            35566478  512         Initialized      NO     160

Scsi   Partition     Container  MultiLevel
B:ID:L Offset:Size   Num Type   Num Type   R/W
------ ------------- --- ------ --- ------ ---
0:00:0 64.0KB:8.47GB  0  Volume  0  None   RW
0:01:0 64.0KB:8.47GB  0  Volume  0  None   RW

Scsi B:ID:L Usage      Size
----------- ---------- -------------
  0:00:0     Container 64.0KB:8.47GB
  0:00:0     Free      8.47GB:8.47GB
  0:01:0     Container 64.0KB:8.47GB
  0:01:0     Free      8.47GB:8.47GB