AACRAID cache problem
"Joakim Tjernlund" <[email protected]> Tue, 11 Nov 2003 11:59:14 +0100
| Newsgroups | gmane.linux.drivers.aacraid.devel |
|---|---|
| Message-ID | <000c01c3a842$d8a4c210$0a01a8c0@LUMENTIS02> |
Hi List
I noticed that my readahead cache in my PERC 3/Di RAID controller has
zero size, but the readahead cache is enabled. How is this possible and
how do I restore the readahead cache size? Can I mess with the cache settings
in a live RH 7.3 system?
Jocke
Details from afacli:
Executing: container list
Num Total Oth Chunk Scsi Partition
Label Type Size Ctr Size Usage B:ID:L Offset:Size
----- ------ ------ --- ------ ------- ------ -------------
0 RAID-5 84.7GB 32KB Open 0:00:0 64.0KB:16.9GB
/dev/sda Lumentis01 0:01:0 64.0KB:16.9GB
0:02:0 64.0KB:16.9GB
0:03:0 64.0KB:16.9GB
0:04:0 64.0KB:16.9GB
0:05:0 64.0KB:16.9GB
AFA0> container show cache 0
Executing: container show cache 0
Global Container Read Cache Size : 0
Global Container Write Cache Size : 118259712
Read Cache Setting : ENABLE
Write Cache Setting : ENABLE WHEN PROTECTED
Write Cache Status : Active, protected
AFA0>
AFA0> controller details
Executing: controller details
Controller Information
----------------------
Remote Computer: .
Device Name: AFA0
Controller Type: PERC 3/Di
Access Mode: READ-WRITE
Controller Serial Number: Last Six Digits = 0410D1
Number of Buses: 1
Devices per Bus: 15
Controller CPU: i960 R series
Controller CPU Speed: 100 Mhz
Controller Memory: 128 Mbytes
Battery State: Ok
Component Revisions
-------------------
CLI: 3.0-0 (Build #4880)
API: 3.0-0 (Build #4880)
Miniport Driver: 2.7-1 (Build #3571)
Controller Software: 2.7-1 (Build #3571)
Controller BIOS: 2.7-1 (Build #3571)
Controller Firmware: (Build #3571)
_______________________________________________
Linux-aacraid-devel mailing list
[email protected]
http://lists.us.dell.com/mailman/listinfo/linux-aacraid-devel
Please read the FAQ at http://lists.us.dell.com/faq or search the list archives at http://lists.us.dell.com/htdig/