Re: linksys wusb11 v2.8 spotty connection

> are there any syslog messages related to the drops (like the device looses
> the AP and gets it back)? Set the debug parameter to 0x180003.

I don't have syslog, it just prints kernel messages to the console. But
i didn't see any messages. But I didn't have the debug set, I will try
that. And I see no dropped packets in ifconfig.

> How do you see that the connection goes out for a few seconds?

I notice when I connect via a telnet session (I know, bad telnet, but
its all I've got). I connect, start typing, it hangs for a sec, I can
type again, it hangs again, etc, etc.

A little more information about my system ... It is for a robot with an
on-board SBC running Linux on an ARM7 @ 60MHz.

One of my thoughts is that it could be a performance thing, but I never
saw this with the WUSB11 v2.6 under the atmel wlan SF driver. 

Thanks!
 - Joe Monti
-- 
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
[ Joseph Monti                                            ]
[ [email protected]                                   ]
[ http://www.smartrobots.com/                             ]
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=