Re: Problem using CVS Tarball on 2.6.5 kernel

Ewan Grantham <[email protected]>
Newsgroups gmane.linux.drivers.at76c503a.user
Message-ID <[email protected]> 
On Fri, 13 Aug 2004 01:03:35 +0200 (CEST), Joerg Albert
<[email protected]> wrote:
> Call "modprobe -v at76c505-rfmd2958", _not_ "modprobe -v
> at76c505-rfmd2958.ko" !

Rebuilt to make sure the 2958 version was installed properly, and then
did a modprobe as you show above rather than modprobe -v at76c503 as I
had understood from the readme.

Doing so shows a number of messages indicating the drivers are
loading, and lsmod shows the drivers as loaded, but iwconfig wlan0
still returns with no such device. Do I need to do something to make
sure the drivers are loading as wlan0? Any other ideas? I've tried
both with it plugged in when I boot, and not plugged in initially but
after login.

Thanks in advance,
Ewan
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.