Topcom Skyr@cer

I ran:

cvs -d:pserver:[email protected]:/cvsroot/at76c503a login
cvs -d:pserver:[email protected]:/cvsroot/at76c503a co at76c503a
cd at76c503a/
make
make install

When I insert my USB Topcom Skyracer directly in the USB-port I get:

Oct  1 21:49:56 medi kernel: uhci_hcd 0000:00:1f.4: wakeup_hc
Oct  1 21:49:56 medi kernel: uhci_hcd 0000:00:1f.4: port 1 portsc 0083
Oct  1 21:49:56 medi kernel: usb 2-1: new full speed USB device using 
address 14
Oct  1 21:49:56 medi kernel: uhci_hcd 0000:00:1f.4: uhci_result_control: 
failed with status 500000
Oct  1 21:49:56 medi kernel: [df014240] link (1f0141e2) element (0e9a8080)
Oct  1 21:49:56 medi kernel:  Element != First TD
Oct  1 21:49:56 medi kernel:   0: [ce9a8040] link (0e9a8080) e3 Length=7 
MaxLen=7 DT0 EndPt=0 Dev=0, PID=2d(SETUP) (buf=1b3e17c0)
Oct  1 21:49:56 medi kernel:   1: [ce9a8080] link (00000001) e3 IOC 
Stalled Babble Length=7ff MaxLen=7ff DT1 EndPt=0 Dev=0,PID=69(IN) 
(buf=00000000)
Oct  1 21:49:56 medi kernel:
Oct  1 21:49:56 medi kernel: uhci_hcd 0000:00:1f.4: uhci_result_control: 
failed with status 440000
Oct  1 21:49:56 medi kernel: [df014240] link (1f0141e2) element (0e9a8040)
Oct  1 21:49:56 medi kernel:   0: [ce9a8040] link (0e9a8080) e0 Stalled 
CRC/Timeo Length=7 MaxLen=7 DT0 EndPt=0 Dev=0, PID=2d(SETUP) 
(buf=1b3e17c0)
Oct  1 21:49:56 medi kernel:   1: [ce9a8080] link (00000001) e3 IOC Active 
Length=0 MaxLen=7ff DT1 EndPt=0 Dev=0, PID=69(IN) (buf=00000000)
Oct  1 21:49:56 medi kernel:
Oct  1 21:49:56 medi kernel: usb 2-1: device not accepting address 14, 
error -71
Oct  1 21:50:00 medi kernel: hub 2-0:1.0: Cannot enable port 1.  Maybe the 
USB cable is bad?

(note: there is no cable! It is directly plugged in)

I tried:

http://lists.berlios.de/pipermail/at76c503a-user/2003-September/000486.html

getting:

  /usr/src/atmel/at76c503a/at76c503-fw_skel.c: Atmel at76c503 
  (RFMD/Accton) Wireless LAN Driver v0.12beta19-static loading
  usbcore: registered new driver at76c503-rfmd-acc

I am running kernel 2.6.8.1


/Ole