Re: at76c503a With FC6 anyone?

Hello!

On Fri, 2006-12-15 at 15:49 +0000, [email protected] wrote:
> So (with Internet access at last!) I updated from cvs.
> 
> The re-compile still complained about the missing config.h file. How
> do I "remove the references to linux/config.h"?

I meant to remove the include statement in the source file.  Now it's
fixed in CVS properly.

> Now the module seems to load but - even with all the same settings
> (ESSID and WEP code) it does not seem to associate:
[skip]
>           Encryption key:XXXX-XXXX-XXXX-XXXX-XXXX-XXXX-XX   Security mode:open

Maybe the AP uses shared key authentication.

> Any ideas anyone?

Try to isolate the problem by using different hardware and software.

-- 
Regards,
Pavel Roskin