Kernel 2.6 and Linksys WUSB11 2.8 error...

Hello everyone,

Since I didn't receive a response to my previous message, I went ahead 
and installed the driver anyway.

Here's what happened. Version 0.11 did not work at all (i.e., it did not 
compile). Therefore, I downloaded the latest CVS snapshot (0.12b4) and 
tried it. It successfully compiled and installed. I then unplugged and 
replugged the device. I ran lsmod and saw that the correct drivers were 
loaded by hotplug. Then I looked in /dev and I didn't see a single wlanX 
nor an ethX device. I therefore ran dmesg and found these two errors:

at76c503.c: config descriptor too short (expected >= 32, got 25)
at76c503.c: unexpected opmode 224

I'm running Slackware 9.1 with kernel 2.6.0. Any ideas?

Thanks,
Robert