Re: BenQ AWL400 - Configured but not working
Timothy Parez <[email protected]>
| Newsgroups | gmane.linux.drivers.at76c503a.user |
|---|---|
| Message-ID | <[email protected]> |
Joerg Albert wrote: >Hi, > >On Sat, 10 Jan 2004, Timothy Parez wrote: > > > >>>alternative way (as described in >>>http://at76c503a.berlios.de/support.html): >>> >>> <plug your device in, open the netdev> >>> iwpriv wlan0 set_debug 0x180003 >>> iwconfig wlan0 essid FLYNET >>> <watch your syslog> >>> >>> >>> >>> >>> >>Ok, I've done this, the syslog now looks like >> >>... >> >> > >your netdev wlan0 is not open, please exec. > ifconfig wlan0 ip_address >afterwards, otherwise the driver won't activate the device. > >/Jörg >_______________________________________________ >at76c503a-user mailing list >[email protected] >http://lists.berlios.de/mailman/listinfo/at76c503a-user > > > what about DHCP ?